Installing
Fitting Signabracket
1. Insert the prongs of the signAbracket into the openings of the corrugated plastic and push the signAbracket onto the sign.
2.Secure the signAbracket to your sign by inserting the two sign securing screws.
Flat Wall Install
1. Secure signAbracket to a flat surface using screws.
2. Then fit and secure your sign to the signAbracket.
Corner Install
1. Holding the signAbracket onto corner, secure the signAbracket in place.
2. Then fit and secure your sign to the signAbracket.
Small Pole Install
1. Fit and secure signAbracket to your sign, then insert cable ties through signAbracket.
2. Fit signAbracket to pole and tighten the cable ties with pliers.
Large Pole Install
1. Fit and secure the signAbracket to your sign, then insert steel strapping through signAbracket.
2. Fit signAbracket to pole. Tighten and secure steel strapping in place.
Dual Pole Install
1. Measure distance between poles and produce sign at 5mm less than distance measured.
2. Fit and secure signAbrackets to your sign. Insert cable ties through signAbrackets. Install sign and tighten cable ties.